Stationary Gateway Configuration (Power Center)
Power Center is a Windows® based software and acts as the primary tool for configuring Galooli’s gateways, extensions, and sensors.
The system uses standard Windows features and styles such as toolbars, menus, and property pages.
To download and install the Power Center, use the following link
Main Features
Interface with Galooli gateways
Read the current values and settings
Serial/Physical upgrade/downgrade gateways firmware
Change the ID for sensors: DC meter, AC meter, and fuel sensor
Serial/Physical configurations
Log-In Process
It is very easy and intuitive for the user to log in to the Power Center platform. Username (Email) and password are the same as those configured on the main Galooli Solution platform - Galooli Solution | Log In Process
Upon successful registration, you will not be required to enter a username or password again, unless the Power Center was deleted and reinstalled, or a version update was performed.
If you are a global user, please enter the name of the organization after the email using &.
Users who forget their password should reset the password via the Galooli Solution platform - How to Reset Password?.
If you are unable to register despite recovering your password, you must verify that you have the appropriate permissions to access Power Center. The permissions called “Hardware Configuration Tools”. Permission Management | General Authorization Permission
In the event you use a Windows operating system on your computer, you may receive a security warning when you attempt to install Power Center or when you perform a version update of Power Center. To proceed with the process, please refer to the image below.
Minimal System Requirements
System Requirements | |
|---|---|
Processor: Multicore Intel/ AMD Processor | Windows 10 and higher |
Memory: RAM -2GB or Higher | .NET Framework Version 4.7 and up |
Note! 64-bit system is recommended, but the 32-bit system is fully supported as well. | |
Misc Menu
Administrator Login - Login with your username and password as supplied by the Galooli support team.
RTU / ELARA - Configuration menu for Galooli Gateways (Ultragate & Elara).
All Devices - Configuration menu for Galooli other Gateways.
Services Center
Allows the user to change parameters in the sensor, such as ID, bound rate, and zero calibration and user the Cuttrough tool.
Bottom Navigation Bar
The bottom navigation bar allows the user to receive an indication of the connection of the various units and define the form of connection to the units.
This section indicates the connection of the units via colors (red and green)
Active Device - Selection of options for connecting to the Gateways:
The “Power Device” option should be selected in case of connection to EX20ETH, EX20
The “TR7Z-TR5” option should be selected in case of TBA
The “RTU/ELARA” option should be selected in case of connection to Elara/Ultragate gateways
Connection Via - Type of connection to the gateway (OTA or Serial)
A voltage of at least 3.5 volts is required for the OTA connection.