/
Power Center Gateway CAN J1939 Device Configuration

Power Center Gateway CAN J1939 Device Configuration

Owned by arkadi kaplon
Last updated: 14.05.25
image-20250514-104213.png

  • Device
    As a list of accessories and devices supported by the Gateway, each part changes depending on the element selected in the part above it.

  • Virtual Device ID
    A virtual number within the Galooli system identifies the device.

  • Linked Device
    A way to configure multiple devices with the same virtual ID.

    The goal is to build one device that will combine data from physically different components (for example, the battery voltage from one device that measures voltage and the battery state of charge from another device that calculates percentage).

    The "Linked Device" should be marked to identify the linked device. The device will be considered a primary unit if the "Linked Device" is not marked.

  • Can Silent Mode
    This mode allows a device connected to the CAN (Controller Area Network) bus to passively monitor all network traffic without transmitting any data or affecting the communication flow. It is typically used for diagnostics, testing, or data logging purposes, ensuring that the device does not interfere with other active participants on the network.

There is a global setting for CAN Silent Mode. It is important to verify whether this global setting is enabled. If it is not, the mode will be determined at the unit level. If the global mode is enabled, all units will operate according to the CAN Silent Mode setting.
https://galooli.atlassian.net/wiki/x/P4Dkq

  • Start Delay [mS]
    TBA

  • Query Delay [mS]
    TBA

  • Query Timeout [mS]
    TBA

  • Query Retries
    This parameter determines the number of times to remain in each register or object before concluding that communication is not normal. In general, the default value is 2 and this is the recommended value. it is recommended that you consult Galooli's support if you wish to change this value.