Leoch Batteries

Averge Technologies is a subsidiary under Leoch International

1 Supported Model
2 Communication Method
3 Pinout/Wiring Diagram
4 Physical Installation
5 Device Configuration
6 Power Center Configuration
7 Supported Parameters
8 Alarms List
9 Manufacturer Data

Supported Model

100Ah

Communication Method

RS485 (Modbus)

Pinout/Wiring Diagram

Pin 1 : RS485 B− (T/R−) Pin 2 : RS485 A+ (T/R+) Pin 3 : GND Pin 4 : Reserved Pin 5 : Reserved Pin 6 : GND Pin 7 : RS485 A+ (T/R+) Pin 8 : RS485 B− (T/R−)

Pin 1 : RS485 B− (T/R−) Pin 2 : RS485 A+ (T/R+) Pin 3 : GND Pin 4 : Reserved Pin 5 : Reserved Pin 6 : GND Pin 7 : RS485 A+ (T/R+) Pin 8 : RS485 B− (T/R−)

Physical Installation

Connect an Ethernet LAN cable from the Galooli Gateway/Computer to the RS485 A port on the left side of the first battery. Ensure that the right-side RS485 port is used to connect the first battery to the left-side RS485 port of the second battery. Continue this daisy-chain connection for all additional batteries.

It is recommended, whenever possible, to connect the smart batteries to RS485 Port 2, separately from other RS485-connected devices and sensors such as fuel sensors, power meters, etc. This approach enhances surge protection for the batteries and isolates them from potential surges affecting the other RS485-connected devices.

Device Configuration

If you, as a user, wish to view the battery data directly through the battery’s own portal and compare it with the values shown in Power Center, follow these steps:

Download and open the “PbmsTools V2.4 file”. Extract the file and run the “Pbms tool”. Below display will be shown, select the serial port for your laptop, open the port.

For configuring the physical ID when there are one or more batteries connected to one another, the following actions must be taken. As shown in the table, the "ADD" part must be configured according to the number of batteries, on each battery separately.

Power Center Configuration

ID assignments:

Battery	Physical ID	Virtual ID	Baudrate
1	1	70	19200
2	2	71	19200
3	3	72	19200
4	4	73	19200
5	5	74	19200

Supported Parameters

Power Center Parameters	System Parameters	Remarks

Power Center Parameters	System Parameters	Remarks
Voltage	Smart_Battery_X.Voltage [V]
Current	Smart_Battery_X.Current [A]
Temperature_Ambient	TBA
Temperature_1-2	Smart_Battery_X.Temperature_X[Celsius]	Temperature 1 - cell temperature Temperature 2 - cell temperature Since lithium batteries are prone to catching fire and exploding at high temperatures, there are two temperature meters for the same purpose.
Battery_SOH	Smart_Battery_X.SOH
Battery_SOC_Percentage	Smart_Battery_X.SOC
Battery_Cycles	Smart_Battery_X.Cycles

Alarms List

TBA

Manufacturer Data

TBA