Skip to end of banner
Go to start of banner

Battery Cell Monitoring - Preparation

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 4 Next »

Installation Preparation

Before you get started make sure you have the following:

  • Battery Cell Monitoring kit:
    -Battery Cell Monitoring HUB
    -Battery Cell Monitoring Sensor (2/12 V)
    -Battery Cell Monitoring Hall Sensor
    -Different adapters and cables

  • Elara unit

  • Lead acid batteries

  • The power source of +12V DC to power the Galooli RTU (Elara)

  • Electrical wires

  • ETH wire

  • Electronic tools – screwdriver, multimeter, & f-crimp tool

 Additional information:

  • The Battery Cell Monitoring HUB and the Elara are designed to be installed on a din rail

Configuration Preparation

  • PC or laptop computer

  • Power Center installed - Click here to download. Credential info can be received from your Account Manager or Galooli support

  • ZonMax installed - Click here to download. Credential info can be received from your Account Manager or Galooli support

  • Download the Battery Cell Monitoring Internal Software (PBMS2000 Monitoring Software)

  • RS485 to USB converter - Refer here for driver installation instructions.

Note! Make sure your computer recognizes the COM port at the “Device manager”. Otherwise, install the proper driver.

  • No labels