Skip to end of banner
Go to start of banner

K2 Basic Configuration

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 5 Next »

Once the K2 gateway has been fully installed, please proceed to the following steps in order to configure the K2 gateway in the optimal manner.

Configuration Center

  • Open the Configuration Center platform and establish a connection to the K2 gateway via an OTA connection

  • If there are different devices connected to the K2 gateway, such as an immobilizer, buzzer, or keypad, you should configure them now.

Immobilizer

Manager Application

  • Open the Manager application.

  • Click on “My Contacts” >> ?

  • Click on "My units" >> “My unit” >> Create a new unit or duplicate all the configuration from another source unit. In any case, you should continue to verify the following sections.

  • In “My unit” >> "Overview" tab, set the appropriate "Asset Type" as and set the "Stationary Unit" as "No”.

  • In “My unit” >> “Configuration” tab >> “IO’s” >> If there are different devices connected to the K2 gateway, such as an immobilizer, buzzer, or keypad, you should configure them individually. On the basis of these settings, it will be possible to define events in the system later on.

Immobilizer

Buzzer

Keypad

Towing

Create a new “Output” >> You should select a meaningful name and the correct output. All other options should be filled out as shown in the image.

Create a new “Digital” >> You should select a meaningful name. All other options should be filled out as shown in the image.

  • In “My unit” >> “Configuration” tab >> “Maintenance” >> Set the relevant maintenance data for you vehicle.

  • In “My unit” >> “Configuration” tab >> “Preferences” >> Set the “Minutes to Idle” value if necessary. As an example, if the engine continues to run for five consecutive minutes without the vehicle is moving, then the vehicle is considered to be in idle status. 5 minutes or more is the recommended value.

  • In “My unit” >> “Configuration” tab >> “Installation setup” >> Set the vehicle's initial working time, distance, and other parameters if necessary.

  • In “My unit” >> “Events” tab >> Add all relevant events and set the phone number/email to receive notifications. The following are some tips and suggestions for useful events.

Idle Event

Towing Event

Tips:

  • Make sure the event names are meaningful in order to make them more understandable in real time.

  • Hide the not relevant (Complex)

Panorama Application

  • No labels