...
| Table of Contents | ||||||||||
|---|---|---|---|---|---|---|---|---|---|---|
|
Features
3GPP licensed technology
Wall / pole mounting
Internal antenna
Dimensions 160x 90 x 50 mm
Weight < 400 g
IP 67 enclosure
Ideal for smart metering
Deep building penetration
Low power consumption
Usage within the temperature range: 20 ––+55 C
WM Bus mode S, T and C
868 MHz
OMS 3.x and 4.x compliant
Opt . L Bus, RS 485
LTE band 3,5, 8, 20
Supported protocols: UDP,
HTTP/S, LwM2M
Micro SIM card holder, eSIM
Firmware update via NFC or FOTA
Configuration via NFC
Technical Specifications
|
|
|
|
|
Installation
|
|
|
|---|---|---|
 |  |  |
Configuration (Swan App)
Connect to the device
Download and open the “NFC Configurator” app (Only for Android) and place the NFC touchpoint of your Android device directly over the NFC touchpoint of the gateway. The NFC touchpoint is centered on the front of the device.
If the connection is successful, you will be asked to enter your password. The default password depends on the device variant. This default password should be changed later.
After the password has been entered correctly, you will be asked to reconnect and the main menu of the app will be displayed.
Basic Configurations
Click on the “Configuration” option.
...
Expert Settings
Click on the three dots and check the "Expert Settings".
...
Mobile Network
The “Mobile Network” tab should be configured as shown in the image.
The “APN” - Depending on your mobile service provider
...
Upload
The “Upload” tab configuration should be done as shown in the image.
Step 1 | Step 2 | Step 3 | Step 4 |
|---|---|---|---|
|  | 
|  |
Collect
The “Collect” tad configuration should be done as shown in the image.
Step 1 | Step 2 | Step 3 | Step 4 |
|---|---|---|---|
| 
| 
| 
|
Step 5 | Step 6 | Step 7 |
|---|---|---|
| 
| 
|
Sync Collect
The “Sync Collect“ tab configuration should be done as shown in the image.
...
Time
The “Time“ tab configuration should be done as shown in the image. The device must be configured to +0 time zone.
...
Write the Configurations
At the end of the procedure, click on "Write" and make sure everything is in order.
...
Configuration (Galooli Solution)
Open the Galooli Software solution and log in.
Open the “Manager” application >> My units >> Create a new unit or clone of an existing unit with the same settings.
Additionally to the basic configurations described here, there are some specific and important configurations that need to be performed for the Swan gateway.
...