Page Comparison

Once the K2 gateway has been fully installed, please proceed to the following steps in order to configure the K2 gateway in the optimal manner.

Configuration Center

• Open the Configuration Center

...

• ?

• Buzzer Control

2. Manager Application

• Add unit

• Preferences - idle

• Installation setup

• Maintenance

• Output configuration

  • IOS

  • Towing

  • Key Pad?

  • Immobilizer?

  • Contacts

• Events

  Only relevant

  platform and establish a connection to the K2 gateway via an OTA connection

• If there are different devices connected to the K2 gateway, such as an immobilizer, buzzer, or keypad, you should configure them now.

Immobilizer
Image Added

Manager Application

• Open the Manager application.

• Click on “My Contacts” >> ?

• Click on "My units" >> “My unit” >> Create a new unit or duplicate all the configuration from another source unit. In any case, you should continue to verify the following sections.

• In “My unit” >> "Overview" tab, set the appropriate "Asset Type" as and set the "Stationary Unit" as "No”.

• In “My unit” >> “Configuration” tab >> “IO’s” >> If there are different devices connected to the K2 gateway, such as an immobilizer, buzzer, or keypad, you should configure them individually. On the basis of these settings, it will be possible to define events in the system later on.

Immobilizer	Buzzer	Keypad	Towing
Create a new “Output” >> You should select a meaningful name and the correct output. All other options should be filled out as shown in the image.			Create a new “Digital” >> You should select a meaningful name. All other options should be filled out as shown in the image.
Image Added			Image Added

• In “My unit” >> “Configuration” tab >> “Maintenance” >> Set the relevant maintenance data for you vehicle.

• In “My unit” >> “Configuration” tab >> “Preferences” >> Set the “Minutes to Idle” value if necessary. As an example, if the engine continues to run for five consecutive minutes without the vehicle is moving, then the vehicle is considered to be in idle status. 5 minutes or more is the recommended value.

• In “My unit” >> “Configuration” tab >> “Installation setup” >> Set the vehicle's initial working time, distance, and other parameters if necessary.

• In “My unit” >> “Events” tab >> Add all relevant events and set the phone number/email to receive notifications. The following are some tips and suggestions for useful events.

...

...

How to configure the towing directly with out the advanced calculation

...

notifications

...

Panorama Application