In the event that a preliminary configuration process between Elara and the rectifier has already been completed, proceed to the “Adding Modbus ETH Device” section listed below.
If the configuration process between Elara and the rectifier is not necessary, change the IP address manually before proceeding to the “Adding Modbus ETH Device”.
Double-click the “Network” row
2. Change the data settings to the following values:
Network Mask - 255.255.255.0
Network Gateway - 192.168.8.1
Elara IP - 192.168.8.101
3. Click on “Write Configuration”
Adding Modbus ETH Devices
Click on the “Configuration” tab
Add a Modbus ETH device
The relevant devices should be selected as described in the image below
If you have configured the rectifier, take note of the hub IP address that you have configured in the "Hub Configuration" section. If no configuration is required for the rectifier, write the default hub IP address 192.168.8.100.
Apply the changes
6. Click on “Write Configuration”