In some cases, a customer wishes to integrate a new hardware product that he intends to use into the Galooli systems and make it a defaulted product. New Integration process conducted by the client and Galooli together. In order to ensure that the product works and synchronizes with Galooli systems correctly, it is imperative that the process is completed accurately and according to the instructions attached to this document.
Client Part
It is the client's responsibility to gather all data relevant to the hardware product and carry out the following actions in the Galooli system.
Gather the following data about the hardware product:
Model
Registry or OID’s
Communication method
This information can be found in the product's technical specifications/datasheet. You may need to contact the manufacturer if necessary.
Please ensure that the Elara gateway and the new device are in the office.
Ensure that the new device is connected to your computer.
Set the device ID using the manual guideline that came with the device. Keep a record of the device ID so you can use it later.
Disconnect the device from the computer.
Download the Galooli Power Center platform.
Assemble the Elara gateway and connect it to a power source and your computer.
Connect the the new device to the Elara gateway.
Open the Power Center and make a serial connection to the Elara gateway.
Configure the new device in the Power Center:
We will now demonstrate an example on how to integrate a new generator panel (RS485).
Depending on the device communication method/protocol, select the appropriate method of adding the device to the Power Center.
Select the appropriate device type and any model of the device from the list. Following this action, you must change the "Physical Device ID" to the device ID you specified in the previous paragraph (Paragraph 4). Click “Apply”.
Later in the document, you will find a table summarizing the recommendations for selecting a model when integrating a new product. The specific model indicated in the table contains the most parameters for the purpose of integration, so we recommend it.
Click "Write configuration", wait until the process is complete, and then click "Reset".
Choose the "Configuration" tab, double click on the existing device, and delete all the registers one by one. The ID and Port lines should not be erased.
After all the registers are erased, click on the “Port” line and click on “Add item”.
>> WRITE CONFIGURATION >> RESTART >> לבדוק שיש ערך בENGINE
e. להוסיף את הפרמטר הבא לפי צילום המסך שעשית לפני תחילת התהליך >> להוסיף את הפרמטר הבא ולחזור על הבדיקה שצוינה מעלה
f. וודא שהערך של כל פרמטר תקין
אחרי שסיימת להוסיף את כל הפרמטרים יש לעשות SAVE AS >> לתת שם
להוסיף אלרמ ליסט + רימוט קונטרול פרמיטרס מתוך המניואל (אם יש ) - חשוב להגיד אם יש או אין
לפתו טיקט לתמיכה, לציין שהכל תקין, היחידה מחוברת, להוסיף את הגיב. תוסיפי לי את זה ליחידות הדיפולטיות
Galooli Part
בודק את הפניה ומבקש, אם היחידה מחוברת אז שכל הערכים תקינים
בדיקה מול איתמר להוספת המכשיר כברירת מחדל
איתמר מממש את הדיפולט