Page Comparison

Power Supply

12-65 v

Power Consumption

Full power mode

0.75W

Low Power mode

0.5W

Stand-by mode

0.25W

OTA (Over The Air) Connection

A voltage of at least 3.5 volts is required for the OTA connection

Backup battery

Type

Li-Ion (2500mAH)

Working Time

Between 10 – 12 hours

GSM/GPRS

Antenna type

Internal

LTE, UMTS/HSPA(+) and GSM/GPRS/EDGE coverage

SIM Card Type

Nano SIM slot

SIM Card Data Usage

Based on a daily data usage test performed on the Elara gateway with a rectifier, fuel sensor, AC and DC meters connected, the daily monthly usage was 50 megabytes.

The conditions of the test:

• Network stability/online availability > 97.5%.

• Once a minute transmission.

• Any additional device may increase the consumption of data.

• Data consumption is not calculated for initiated queries, upgrades, reading and writing data per unit, cut through, and X-ray.

GNSS

Antenna type

Internal

GNSS Systems

99 acquisition channels

33 tracking channels

GPS Support

GLONASS Support

Sensitivity

-167 dBm

Main Serial Communication

Type

RS485 Protected Ports

Surge Protection

IEC 61000-4-5 Class 4

Secondary Serial Communication

Type

RS485 Protected Ports

(Hardware dependent)

Surge Protection

IEC 61000-4-5 Class 4

Analog Inputs

Count

5

Voltage Range

0-15v

Type

Voltage / Temperature / Pulse Counter

Outputs

Count

1

Type

Open Collector

Ethernet Port

Ports

1

Interface Standard

8 pin RJ45

Network interface protection

2KV electromagnetism isolation

shell insulation blocking

Memory logger

Type

Micro-SD card

Size (Messages)

An 8GB SD card is included with the Elara.

Please refer to the following link for more detailed information regarding the storage.

https://galooli.atlassian.net/l/cp/J1k2z4wT

Movement detection

Type

MEMs

Axes

3

Storage Temperature

-40 - 85 Celsius

Working Temperature

-20 - 70 Celsius

Max. Relative humidity

90%

Weight

154gr (No Battery) 

176gr (Battery included) 

Size

Width 85.5 x Length 86mm 

Height 63mm 

Daisy Chain Support

Connecting different accessories to the same wires rather than running two separate wires from each meter

State 

Pattern 

Color 

SD Activity 

Short Blink 

(100mS) 

Green 

No SD Card detected 

Fast blink 

(100mS On, 100mS Off) 

Red 

General Hardware Issue
(Including a problem with the SD card that probably requires replacement)

Steady without blinking

Red 

Missing / Corrupted Configuration file 

Slow blink 

(100mS On, 750mS Off) 

Red