...
יש רקטיפייר:
מוסיפים את הרקטיפייר
אין רקטיפייר:
אין רקטיפייר אז פשוט רושמים את הIP הדיפולטי של הDFUN בPOWER CNETER הRANGE ולא אותו מספר
NETWORK too
צריבה ושמירה
לבדוק אלרה IP
לרשום IP נכון
add modbus eth driver
Chnage IP
ZonMAX >> LAYOUTAfter you have configured the ID of the device, you can now connect the AC meter directly to the Elara unit as described in the CE Transducer CE42 Installation document.
Open the PowerCenter (if the power center was already open, close, and re-open it).
Open the “Active Device” drop-down menu and select “Elara”.
Open the “Connect Via” drop-down menu and select the relevant Serial COM port.
...
4. Navigate to the “Elara” tab.
...
5. Navigate to the “Configuration” tab
6. Click the “Read Configuration” button.
...
7. In the Configure tab click the “Add Port 1 Device”.
...
8. The “Elara – Modbus Device Configuration” window will pop up:
a. Open the “Devices” first drop-down menu and select “AC_ Meter”.
b. Open the “Devices” second drop-down menu and select “CE42.”
c. Choose the most suitable ring according to the size conversion ratio.
...
d. Input the ID of the sensor in the “Physical Device ID” & “Virtual Device ID” (according to the previous configuration).
...
e. Make sure the “Device Budrate” is 19200, as you set it earlier.
f. Click “Apply”.
9. Click the “Write Configuration” button to save the changes.
...
10. Click the “Reset” button.
...
11. Navigate to the “Status” tab to view the status of the AC Meter.
...
In the event that a preliminary configuration process between Elara and the rectifier has already been completed, proceed to the “Adding Modbus ETH Device” section listed below.
If the configuration process between Elara and the rectifier is not necessary, change the IP address manually before proceeding to the “Adding Modbus ETH Device”.
Double-click the “Network” row
...
2. Change the data settings to the following values:
Network Mask - 255.255.255.0
Network Gateway - 192.168.100.1
Elara IP - 192.168.100.101
...
3. Click on “Write Configuration”
Adding Modbus ETH Devices
Click on the “Configuration” tab
Add a Modbus ETH device
The relevant devices should be selected as described in the image below. All of the steps described from this step and below should be performed on the second string if you are working with two strings.
If you have configured the rectifier, take note of the hub IP address that you have configured in the "Hub Configuration" section. If no configuration is required for the rectifier, write the default hub IP address 192.168.8.100.
Apply the changes
...
6. Click on “Write Configuration”
7. In the case of two strings, go back to step 3 and select the second string. Then, repeat the process for the second string.