After you have configured the ID of the device, you can now connect the DC meter directly to the Elara unit as described in the DC Meter CE11 Installations document.
Re-open Power Center.
Open the “Active Device” dropdown and select “Elara.”
Open the “Connect Via” dropdown and select the relevant “COM port”.
Navigate to the “Elara” tab.
Navigate to the “Configuration” tab and click “Read all parameters” under the Elara device.
Click the “Add Port-1 Device”.
Select relevant device information according to the previous configurations.
...
Pay attention to the model of the CE Transducer CE11 device. For example:
...
ID 1-5 - Batteries meter
ID 34 - Solar meter
ID 60-69 - Tenants 1-10
ID 90-99 - Tenants 11-20
8. Click the “Write All Parameters” button to save the changes and reset the unit.
...
Return to the “Configuration” tab and confirm that the DC meter setup was registered.
