Power Center is a Windows® based software and acts as the primary tool for configuring Galooli’s gateways, extensions, and sensors.
The system uses standard Windows features and styles such as toolbars, menus, and property pages.
To install the Power Center, use the following link
Main features
Interface with Galooli gateways: Elara, TR7Z-K2, TR7Z-TR5, EX-20, EX-THE, EX 20-SSR, EX6I and sensors, DC meters, AC meters, and fuel sensors
Read the current values and settings
Serial/Physical upgrade/downgrade gateways firmware
Change the ID for sensors: DC meter, AC meter, and fuel sensor
Serial/Physical configurations
| Table of Contents |
|---|
Minimal System Requirements
System Requirements | |
|---|---|
Processor: Multicore Intel/ AMD Processor | Windows 10 and higher |
Memory: RAM -2GB or Higher | .NET Framework Version 4.7 and up |
Note! 64-bit system is recommended, but the 32-bit system is fully supported as well. | |
Misc Menu
Restore - This button resets the structure of the screen in case changes were made
Administrator login - Login with your username and password as supplied by the Galooli support team
...
Services Center
Allows the user to change parameters in the sensor, such as ID, bound rate, and zero calibration.
...
Configuration tools
Wizard-based configuration tools, allowing sensor/device-specific parameters update, baud rate update, and other relevant parameters configuration
Explorer
Links that lead to tabs on the right (the sensor types)
Double click on the gateways tabs will open the suitable information in the center working area
...
Tools:
Messages - After clicking this button, a page appears on the right side of the screen that shows the communication log of the gateway
Working Area
The visibility and characteristics of the working area vary depending on the gateway selected
...
Bottom Navigation Bar
The bottom navigation bar allows the user to receive an indication of the connection of the various units and define the form of connection to the units.
This section indicates the connection of the units via colors (red and green)
...
Active Device - Choose the relevant device. The “Power Device” option should be selected in case of connection to EX20ETH, EX20
Connection Via - Type of connection to the gateway (OTA or Serial). A voltage of at least 3.5 volts is required for the OTA connection.
...
| Child pages (Children Display) |
|---|