...
Driver Identification & Immobilizer Section | Driver Identification & Immobilizer Section | Buzzer Control Section | Fuel Section |
|---|---|---|---|
It's recommended to use this option if you want the driver to identify himself before the trip starts.  Read more - Configuration Center Configuration If you choose to have the driver identify himself before the trip begins, and the identification is performed using the Dallas Key, then the relevant information must be included here.  Read more - Configuration Center Configuration In the event that you decide to monitor the drivers' activities and link the vehicle to driver, you must perform another step in the system as described in the following page - My Contacts | If the vehicle has an immobilizer, this is where you define how it works.   Read more - Configuration Center Configuration | If the vehicle has a buzzer installed, this is where you define how it works.  Read more - Configuration Center Configuration | In the case of an external fuel sensor, this is how you define its operation.  It is recommended that the "Noise Factor" be set at "Standard". Read more - Configuration Center Configuration You create a fuel calibration table as described in the following page - My Calibration |
...
Immobilizer | Towing | Fuel |
|---|---|---|
Create a new “Output” >> You should select a meaningful name and the correct output. All other options should be filled out as shown in the image. | Create a new “Digital” >> You should select a meaningful name. All other options should be filled out as shown in the image. | Create a new “Analog” >> You should select a meaningful name. All other options should be filled out as shown in the image. |
  |   |   |
In “My unit” >> “Configuration” tab >> “Maintenance” >> Set the relevant maintenance data for you vehicle.
In “My unit” >> “Configuration” tab >> “Preferences” >> Set the “Minutes to Idle” value if necessary. As an example, if the engine continues to run for five consecutive minutes without the vehicle is moving, then the vehicle is considered to be in idle status. 5 minutes or more is the recommended value.
In “My unit” >> “Configuration” tab >> “Installation setup” >> Set the vehicle's initial working time, distance, and other parameters if necessary.
In “My unit” >> “Events” tab >> Add all relevant events and set the phone number/email to receive notifications. The events are based in part on the IO's and other configurations that you have made.
The following are some tips and suggestions for useful events.
...