Supported Models
HGM6120N (Generator Controller)
SGUE485 (USB to RS485 Converter)
Communication Method
RS485 (Via Convertor)
Network configuration
Device Baudrate | 9600 |
|---|
Supported Services
Parameters | Alarm Name | Alarm Criticality | Remote Controlling |
|---|---|---|---|
Engine Hours |
|
| |
Voltage_Phase_1-2 |
|
| |
Grid_Voltage_Phase_1_3 |
|
| |
Current_Phase_1-3 |
|
| |
Frequency |
|
| |
Engine_Speed |
|
| |
Battery_Voltage |
|
| |
Coolant_Temperature |
|
| |
Oil Pressure | |||
Total Output KWH | |||
Working_Mode |
|
|
Installation and Configuration
Preparation
Galooli Gateway (Including an active SIM card).
Power source for the Gateway.
Power cables for the Gateway. Two cables with a thickness of 0.5mm. The length of the cables is determined by the distance between the power supply and the Gateway.
SmartGen Geset HGM6120N Controller + SGUE485 (USB to RS485 Converter).
2 x 120 ohm resisters.
Screwdriver (Slotted & Phillips).
Installation
In the installation process mentioned bellow, the images and steps describe the Galooli Elara gateway installation, however any other Gateway can be connected.
Assemble the Galooli gateway and ensure there is a power source available and that it is connected correctly to the Gateway. Gateway Solutions
Connect the USB cable from the SmartGen controller to the SGUE485 (USB to RS485 Converter).
Connect 2 RS485 communication cable between the SGUE485 (USB to RS485 Converter) and the Galooli Gateway RS485 input.
One resistor should be installed on the SGUE485 (USB to RS485 Converter) and one resistor should be installed on the Galooli Gateway.
If necessary, mount all the devices on a din rail.
The Galooli gateway should be powered on.
Ensure that all devices are turned on.
Configuration
TBA