Skip to end of banner
Go to start of banner

Cut Trough - Rectifier

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 6 Next »

The Cut Trough to the rectifier allows you to get data and even set it depending on the data types.

Data Type

Can it be read?

Can it be set?

Data Examples

Static Data - Configuration Data

(tick)

(tick)

“Generator On Voltage”

Static Data - Other Data

(tick)

❌

“Rectifier Device Type”

Live Data

(tick)

❌

“I Load”, “Solar Power”

Cut Trough Progress

  1. Download the “MIB BROWSER” - https://www.ireasoning.com/download.shtml

  2. Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status”. >> Click on “Status” tab. Now you can see all the information about the rectifier that connected to the Elara gateway.

  3. Click on “Direct-Comm” >> Choose “Ethernet (SNMP: LOCALHOST) >> Ensure that the "Gateway", "Destination IP", and "Elara IP" are accurate >> Leave the “Power Center” open.

4. Open the “MIB Browser” platform >> Type “localhost” in the address box >> Click on “Advanced” >> In the window that appears, type the correct “Read Community” and “Write Community” >> Click “Ok”

  • In order to obtain the "Read Community" and "Write Community" codes, please refer to the Galooli Knowledge Base or to the rectifier company.

  • You may leave the "Write Community" field blank if your intention is only to read the configuration and not to write it.

5. The "OID" for the relevant data field should be written in the appropriate location. An "OID" represents a specific field of data. Obtaining the OID can be accomplished by contacting the rectifier company.

6. It is now up to you to decide whether you would like to receive or set data using the OID:

  • In the event that you wish to obtain data via the OID, please select "Get" and then "Go".

  • In the event that you wish to set data via the OID, please select “Set” and then “Go”

7. You can view the rectifier results in the result table. Each time you run a different OID, the data will be added separately to the table.

8. To "set" data in the rectifier, double click the relevant row and you will be presented with a window for editing the data. Editing is only possible for the relevant parameters mentioned above.

  • No labels