CE Transducer CE11 - Preparation

Owned by arkadi kaplon
Last updated: 28.07.24
1 min read

Installation Preparation

Before you get started make sure you have the following:

  • CE Transducer CE11 Meter

  • The power source of +12V DC to power the Galooli RTU (Elara)/CE Transducer CE11

  • Power cables for the Elara/CE Transducer CE11 gateway - two cables with a thickness of 0.5mm. The length of the cables is determined by the distance between the power source and the Elara/CE Transducer CE11 Meter gateway

  • RS485 To USB Converter & two 0.5mm thick communication cables. The length of the cables is determined by the distance between the RS485 to the USB converter and the computer

  • Screwdriver (Slotted & Phillips)

  • Communication cables for the CE Transducer CE11 inputs and outputs. Cables with a thickness of 0.5mm. The length of the cables is determined by the distance between the sensors and the surrounding environment

  • Electronic tools – screwdriver, multimeter, & f-crimp tool

 Additional information:

  • The device is designed to be installed on a din rail

  • Make sure that you have sufficient space for its mounting

Configuration Preparation

  • PC or laptop computer

  • Galooli Software Solution link

  • Power Center installed - Click here to download.

  • RS485 to USB converter - Refer here for driver installation instructions.

  • Technical Booklet - Provided by Galooli Support team.

Note! Make sure your computer recognizes the COM port at the “Device Manager”. Otherwise, install the proper driver.