Skip to end of banner
Go to start of banner

Carlo Gavazzi EM210 Installation and Configuration

Skip to end of metadata
Go to start of metadata

You are viewing an old version of this page. View the current version.

Compare with Current View Page History

« Previous Version 3 Next »

Preparation

Installation Preparation

Before you get started make sure you have the following:

  • Carlo Gavazzi EM210 Meter

  • The power source of +12V DC to power the Galooli RTU (Elara)/Carlo Gavazzi EM210

  • Power cables for the Elara/Carlo Gavazzi EM210 gateway - two cables with a thickness of 0.5mm. The length of the cables is determined by the distance between the power source and the Elara/Carlo Gavazzi EM210 Meter gateway

  • RS485 To USB Converter & two 0.5mm thick communication cables. The length of the cables is determined by the distance between the RS485 to the USB converter and the computer

  • Screwdriver (Slotted & Phillips)

  • Communication cables for the Carlo Gavazzi EM210 inputs and outputs. Cables with a thickness of 0.5mm. The length of the cables is determined by the distance between the sensors and the surrounding environment

  • Electronic tools – screwdriver, multimeter, & f-crimp tool

 Additional information:

  • The device is designed to be installed on a din rail

  • Make sure that you have sufficient space for its mounting

  • We recommend mounting the AC meter next to phase breakers - this act can simplify the process of disconnecting the cables from the breakers, passing the load cables through the meter, and then connecting them back to the breakers

Configuration Preparation

  • PC or laptop computer

  • Galooli Software Solution link

  • Power Center installed - Click here to download.

  • RS485 to USB converter - Refer here for driver installation instructions.

  • Technical Booklet - Provided by Galooli Support team.

Note! Make sure your computer recognizes the COM port at the “Device Manager”. Otherwise, install the proper driver.

Power Connection

  1. Connect the device to a power source with a minimum voltage of 40V. This AC meter's power pins are the phases themselves. One phase is enough to power the meter.

  2. Make sure the LED is lit green.

 Connection to the Computer

It is highly recommended that you perform this step within the office before you leave for the field

  1. Connect the RS485 converter to the PC/laptop and connect the other ends of the wires to that AC meter. RS-458 Adaptor connected to the PC

 

Terminal number

Description

16

RS-485 B data port

15

RS-485 A data port

  • No labels