Supported Models | Communication Methods | Read/Write Community |
Eltek_SmartPack | RS485 | Not Relevant |
|
| Read - public |
Eltek_SmartPack2Touch | SNMP | Read - v1community |
Eltek_SmartPackS | SNMP |
Network configuration for ETHERNET/SNMP connection
Device IP | 192.168.10.20 |
|---|---|
Subnet mask | 255.255.255.0 |
Gateway | 192.168.10.1 |
Host IP (Web/Elara configuration) | 192.168.10.21 |
Network configuration for RS485 connection
Device Baudrate | 19200 |
|---|
RS485 Wiring diagram
SmartPack configuration
Username - admin
Password - admin
SmartPack2 configuration
Smart_Pack2 Touch configuration
SmartPack2 & S Touch SNMP Configuration
The following steps should be taken as soon as you receive your new “SmartPack 2 and S Touch Rectifier”:
1. In order to activate the SNMP option after installation, login to the rectifier controller and copy your
specific MAC address.
2. You will need to contact a representative from "Eltek" to activate the SNMP feature; you will need to
provide the MAC address from the previous paragraph and ask for a "license key.”
3. Once the "license key" has been reserved from "Eltek", enter it and proceed to the next step.
4. Check the “Web-based configuration” to enable the web SNMP configuration.
SNMP is now available
