Cut Trough - Smart Batteries

The Cut Trough to the Smart Batteries allows you to get data and even set it depending on the data types.

Data Type	Can it be read?	Can it be set?	Data Examples
?		TBA	?
?		TBA	?

Cut Trough Progress

Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status” >> Click on “Configuration” tab. Now you can see all the information about the smart battery.

Get Parameters

Click on the “Direct-Comm” >> Select the correct “Port” between the two ports according to the port to which the battery is connected >> Select the correct “Baud Rate” according to the battery’s baud rate.

2. In order to obtain the parameters that you require from the smart battery, you must enter a Modbus command in the "Data (HEX)" box. It is important to note that each Modbus command has a unique structure that will be derived from the parameters that will be taken from the smart battery's configuration settings.

Code Part	Parameter	Notes	Example
1	Smart battery's physical ID	Two digits only 1 >> 01	The image is only for illustration purposes; please do not separate the numbers with spaces
2	Register command number	Two digits only 4 >> 04
3	Register address number	Four digits only 1 >> 0001 It is necessary to convert the addresses from decimal to hexadecimal format. Decimal to Hexadecimal converter
4	Amount of Registers	Four digits only 1 >> 0001

3. To get the smart battery's data about this specific register, click "Send”

4. Data will appear in a unique structure that must be translated via the smart battery configuration parameters, For example:

As you can see in the picture below, we are able to get the value of the smart battery "Temperature 2". The value that we receive from the cut trough is "301", now we need to take this value and convert it to the ratio given next to the type of register [1:10], meaning that the battery temperature is 30.1 degrees Celsius.

Set Parameters

TBA