The Cut Trough to the rectifier allows you to get data and even set it depending on the data types.
Data Type | Can it be read? | Can it be set? | Data Examples |
|---|---|---|---|
Static Data - Configuration Data |
|
| “Generator On Voltage” |
Static Data - Other Data |
| ❌ | “Rectifier Device Type” |
Live Data | | ❌ | “I Load”, “Solar Power” |
Cut Trough Progress
Download the “MIB BROWSER” - https://www.ireasoning.com/download.shtml
Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status”. >> Click on “Status” tab. Now you can see all the information about the rectifier that connected to the Elara gateway.
Click on “Direct-Comm” >> Choose “Ethernet (SNMP: LOCALHOST) >> Ensure that the "Gateway", "Destination IP", and "Elara IP" are accurate >> Leave the “Power Center” open.
4. Open the “MIB Browser” platform >> Type “localhost” in the address box >> Click on “Advanced” >> In the window that appears, type the correct “Read Community” and “Write Community” >> Click “Ok”
In order to obtain the "Read Community" and "Write Community" codes, please refer to the Galooli Knowledge Base or to the rectifier company.
You may leave the "Write Community" field blank if your intention is only to read the configuration and not to write it.
5. The "OID" for the relevant data field should be written in the appropriate location. An "OID" represents a specific field of data. Obtaining the OID can be accomplished by contacting the rectifier company.
אם רוצים לקבל מידע אז GET אם רוצים לקבוע אז SET
10. GO
11. במידה ומופיע שגיאה יש ללחוץ שוב על GO
12. See the value
