...

...

...

...

...

...

Required equipment:

• Computer

• RS485 Converter

• Power Center application (Power Center Introduction)

• Screwdriver

• Communication Cables

Connectivity Instructions:

1. Connect the communication cables to the 1(A) & 2(B) ports in the RS485 converter
   

   

2. Connect the other side of the cables to the Elara RS485 A & B Ports or the Elara tray/box:
   
   If your Elara is connected through a Tray, connect the cables to the gray terminal blocks, labeled DLS & BZR, while DLS is for Port A, and BZR is for Port B, as shown in the pictures:
   

...

4. Plug the RS485 converter into your computer, the converter will light with a red LED.

Power Center Configuration Instructions:

1. Make a serial connection using the Power Center application, as shown in the image below.
   If your computer is unable to detect the converter, please follow the next link.
   
   Elara's "Time Stamp" is determined by the server and not by GPS

...

3. After you double-click the “Network” tab, check the “Server URL”, “Network APN” and the modes in both Port 1+2 (:

• Elara - Port 1 must be the host and Port 2 binary

...

• Elara CAN - Port 1 must be binary and Port 2 host

Then follow the steps below:

...

• If your SIM card has been provided by Galooli, check that the information listed in the tabs matches the information you received from Galooli. Contact Galooli technical support if needed.

• If any other cellular supplier has provided your SIM card, you should contact them to verify the accuracy of the information

...