...
Please note that before starting the process, you must verify whether the parameters you are interested in can be set.
| Table of Contents |
|---|
Cut Through Progress
Download the “MIB Browser” - SNMP Monitoring Software.
Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status” >> Click on “Status” tab. Now you can see all the information about the rectifier that connected to the Elara gateway.
...
3. The next step is to locate and copy 3 different parameters the “Destination IP” in order to be able to make the "Cut Through":
Rectifier IP - Select the "Configuration" tab >> Double-click the "Group: Rectifier” >> Copy the Device IP of the rectifier and save it for later.
Network Gateway & Elara IP - Select the "Configuration" tab >> Double-click the “Group: Device” >> Double click the “Local Network” >> Copy the “Network Gateway” and the “Elara IP”
...
4. Click on “Direct-Comm” >> Choose “Ethernet (SNMP: LOCALHOST) >> Fill in the information you obtained in the previous step >> Keep the “Direct-Comm” window open.
"Gateway" = Network Gateway"Destination IP" = Rectifier IP
“Elara IP" = Elara IP
...
5. Open the “MIB Browser” platform >> Type “localhost” in the address box >> Click on “Advanced” >> In the window that appears, type the correct “Read Community” and “Write Community” based on your requirements >> Click “Ok”
In order to obtain the "Read Community" and "Write Community" codes, please refer to the Galooli Knowledge Base or to the rectifier company.
...