...

The K2 gateway extracts data from multiple sources within the connected vehicle which can then be transformed into actionable business insights.

Features

• SMS configuration commands

• SMS information request commands

• Onboard, 3-axis accelerometer for driver behavior analysis

• In-vehicle, real-time, buzzer indication (Over speeding, Braking, Accelerating, etc.)

• Low power operation mode

• Vehicle Immobilizing control, including smart output control information (Active state, Current detection, and Overcurrent detection)

• Remote version upgrade

• Multiple driver Identification devices support (Dallas button, Keypad, RFID cards)

• Multiple engine computer diagnostic support options - FMS/OBD (using external MILA7 device)

• Multi-function inputs (Configurable as Analog / Digital and State time filtering)

• Direct NTC temperature sensor support (Analog 2 input)

• GSM Jamming detection (with automatic demobilization control) (Not available at 3G model)

...

 Indication Indication LEDs

...

Status LED Indications

...

SMS Commands

Request Commands

Used to request a report message of specific parameter information (without changing the parameter's value):

Request structure (sent by the user via SMS):

...

Supported commands:

...

Update Commands

Used to set a specific parameter.

Upon receiving a valid command, the unit will reply with a 'query parameter' message (as described at the Query 

Commands section).

Command structure (sent by the user via SMS):

...

...

Note: in versions prior to ver 3.02, immobilize! Command had the meaning of mobilizing! (behavior changed at ver 3.02)

Pinout

The TritonK2 use a standard 12-pin harness as described below:

...

• All pins marked as Analog/Digital inputs can operate both as Analog and Digital inputs. Voltage thresholds for digital behavior are defined using the 'Configuration Center' application.

• Negative Digital inputs have an internal pull-up, so 'activating' those inputs is done by connecting to ground.

SMS Commands

K2 gateways are capable of receiving commands via SMS for requesting the status of the gateway or set parameters to the gateway.

To send any type of command to the K2 gateway, you simply have to type in a message (SMS) in your phone and send it to the telephone number associated with the SIM card in the gateway.

Commands Execution

	Request Status Commands	Set Parameters Commands
Types of Commands	A request status command is used to request a report message containing specific parameter information without changing the parameter's value.	A set parameters commands used to set a specific parameter.
Command Identifiers	The Request Status Commands ends with a “?” Image Added	The Set Parameters Commands ends with an “!” Image Added
Commands List & Descriptions	Note Since the commands are case sensitive, they must all be written in lower case. Ensure that the requests are written exactly as described in this article.
	location: ? Requests the current location of the K2 Image Added apn: ? Requests the APN/User/Password of the K2 Image Added host: ? Requests the host URL (Server URL) of the K2 Image Added	host: name of the host! Sets the host URL (Server URL) of the K2. apn: internet! Sets the APN to “Internet”, and clears the User/Password parameters apn: name of the APN,User,Password! Sets the APN and/or User and/or Password of the K2 unit reset! Turns the K2 off and on Image Added mobilize! Enables the immobilizer for 30 seconds immobilizer! Disables the immobilizer