...
In order to use the Colocation NOC solution just open the “Apps” solution and choose “Colocation NOC”.
The app will be similar to the NOC table display.
| Table of Contents |
|---|
Site name - The unit name in the system
Tenant’s site id - Represents the specific site id that the tenant set on this site. The tenant can see data only about their self
Session start time and last alarm time - The time when the unit was added to the list and the last time any of the alarms were activated on the site
Tenant Meter Disconnected - An indication that a meter of a particular tenant is disconnected
Tenant power down - An indication that there is no voltage and no current
Tenant load down - An indication that there is voltage but no current
The alarms that will be shown will be the alarms that were defined through the NOC category configuration
NOC functions like acknowledgment, tickets, etc are not available through this app, it is only for display purposes
Alarms display order is that the latest alarm at the top of the list
...
The NOC system should be active in the organization
Create a new dedicated category for the Colocation NOC, and choose the type “system alarms status”
...
...