...
Please note that before starting the process, you must verify whether the parameters you are interested in can be set.
Cut Trough Progress
Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status” >> Click on “Configuration” tab. Now you can see all the information about the smart battery.
...
As you can see in the picture below, we are able to get the value of the smart battery "Temperature 2". The value that we receive from the cut trough is "301", now we need to take this value and convert it to the ratio given next to the type of register [1:10], meaning that the battery temperature is 30.1 degrees Celsius.
...
Set Parameters
Complete all the steps in this article and proceed to the next step once you have read the parameters.
In order to set parameters, change the “Register command number” to “06” (Always) and the “Amount of Registers” to the value that you want to set.
...