...
Complete all the steps in this article and proceed to the next step once you have read the parameters.
In order to set parameters, change the “Register command number” to “06” (Always) and the “Amount of Registers” to the value that you want to set.
Code Part | Parameter | Notes | Example |
|---|---|---|---|
1 | Inverter physical ID | The physical ID of the inverter should remain unchanged |
 |
2 | Register command number | The register command number should be changed to 06 (always) 03 >> 06 | |
3 | Register address number | The register agrees number should remain unchanged | |
4 | Amount of Registers | Change the amount of registers parameter to the value that you wish to set in Hexadecimal and write it in four digits only. 0003 >> 0007 |
3. Click “Send”