The Cut Trough to the rectifier allows you to get data and even set it depending on the data typesparameters type.
Communication with the rectifier is accomplished through SNMP over Ethernet.
משפט - שים לב
OID
Please note that before starting the process, you must verify whether the parameters you are interested in can be set.
Cut Trough Progress
Download the “MIB Browser” - SNMP Monitoring Software.
Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status” >> Click on “Status” tab. Now you can see all the information about the rectifier that connected to the Elara gateway.
...
5. Open the “MIB Browser” platform >> Type “localhost” in the address box >> Click on “Advanced” >> In the window that appears, type the correct “Read Community” and “Write Community” based on your requirements >> Click “Ok”
In order to obtain the "Read Community" and "Write Community" codes, please refer to the Galooli Knowledge Base or to the rectifier company.
You may leave the "Write Community" field blank if your intention is only to read the configuration and not to write it.
...
6. The Write the "OID" for the relevant data parameters should be written in the appropriate location.(An "OID" represents a specific address of a parameter
...
Obtaining the OID can be accomplished by contacting the rectifier company.
...
7. It is now up to you to decide whether you would like to receive or set the parameters using the OID:
).
In the event that you wish to obtain data via the OID, please select "Get" and then "Go".
In the event that you wish to set data via the OID, please select “Set” and then “Go”.
Obtaining the OID can be accomplished by contacting the rectifier company.
...
Get Parameters
You can view the rectifier parameters results in the “Result Table”. Each time you run a different OID, the A rectifier parameter result can be viewed in the "Result Table" after you select the "Get" operation and run the address. The parameters will be added separately to the table separately each time you run a different OID.
...
Set Parameters
Upon entering the correct OID for a parameter that can be set and clicking "Go", you will be presented with a new window that will allow It is important to verify that the parameters can be edited before attempting to modify them
Upon selecting the "Set" operation and running the address, a new window will appear allowing you to modify the parameter value.וודא פרמטר ניתן להעריכה
...