...
Communication with the smart batteries is accomplished through Modbus over RS485.
Cut Trough Progress
Open the Power Center >> Connect to the Elara gateway via serial/OTA connection >> Click on “Read Configuration” >> Click on “Status” >> Click on “Configuration” tab. Now you can see all the information about the smart battery.
...
Get Parameters
Click on the “Direct-Comm” >> Select the correct “Port” between the two ports according to the port to which the battery is connected >> Select the correct “Baud Rate” according to the battery’s baud rate.
...
As you can see in the picture below, we are able to get the value of the smart battery "Temperature 2". The value that we receive from the cut trough is "301", now we need to take this value and convert it to the ratio given next to the type of register [1:10], meaning that the battery temperature is 30.1 degrees Celsius.
...
Set Parameters
TBA