Required equipment:
...
Connect the communication cables to the 1(A) & 2(B) ports in the RS485 converter
.jpeg?version=1&modificationDate=1654577713047&cacheVersion=1&api=v2&width=142)
.jpeg?version=1&modificationDate=1654577713047&cacheVersion=1&api=v2&width=136)
Connect the other side of the cables to the Elara RS485 A & B Ports or the Elara tray/box:
If your Elara is connected through a Tray, connect the cables to the gray terminal blocks, labeled DLS & BZR, while DLS is for Port A, and BZR is for Port B, as shown in the pictures:
...
4. Plug the RS485 converter into your computer, the converter will light with a red LED.
Power Center Configuration Instructions:
Make a serial connection using the Power Center application, as shown in the image below.
If your computer is unable to detect the converter, please follow the next link.
...
Make sure the “Connection” is “Connected to host”
Make sure the SD card status is “Inserted / configuration OK”
The Elara version should be up-to-date (How To Upgrade Elara Version?)
The Elara IAP version should be up-to-date (How To Upgrade Elara IAP Version?)
The Elara ethernet version should be up-to-date (How To Upgrade Elara Ethernet Port?)
2. Perform the steps as displayed in the image below:
...
4. If you have made any changes it is important to click "write configuration" and then “reset”
...