...

• Computer

• RS485 Converter

• Power Center application (Power Center Introduction)

• Screwdriver

• Communication Cables

Instructions:

• Connect the Elara to the RS485 converter:

  1. Connect the communication cables to the 1(A) & 2(B) ports in the RS485 converter:

     Image Modified

  2. Connect the other side of the cables to the Elara RS485 A & B Ports:
     
     
     If your Elara is connected through a Tray, connect the cables to the gray terminal blocks, labeled DLS & BZR, while DLS is for Port A, and BZR is for Port B, as shown in the pictures:
     

     Image ModifiedImage Modified

     
     
     If your Elara is connected without a tray, e.g. directly, you need to connect the cables to the second RS485 Port (the rightest) in the Elara, as shown in the pictures:

     Image Modified

  3. Make sure the Elara is powered.
     

• Plug the RS485 converter into your computer, the converter will light with a red LED.

...

• Open the Power Center application.

• Part I of the configuration process:
  Perform the steps as displayed in the image bellow

  Image Added

-Make sure the “Connection” is “Connected to host”

-Make sure the SD card status is “Inserted / configuration OK”

-The Elara version should be up-to-date

• Part 2 of the configuration process:
  Perform the steps as displayed in the image below:

• Image Modified

5. After you double-click the “Network” tab, check the “Server URL”, “Network APN” and the modes in both Port 1+2 (Port 1 must be the host and Port 2 binary). Then follow the steps below:

...

6. If you have made any changes it is important to click "write configuration" and then “reset”

...