Performing the ethernet port update process exactly as outlined in this document is important for the proper operation of the Elara gateway.
Make sure that the Elara version and IAP version are up to date.
Connect the Elara to the computer using serial or OTA connections and copy , and open the Power Center. Find the "ELARA IP” in the configuration tab. Save or copy the IP.
In case you have a new Elara that does not have an IP number, you should add SNMP ETH Device
(Rectifier
for example) and this action will create the Elara IP.
...
The Elara IP must be written down exactly as it is (Paragraph 2), but the last number must be changed, as you can see in the example below.
...
6. After you click “OK” a new window will open up. First of all, make sure that the “Local IP Address” is the same as mentioned in paragraph 4, then you will need to choose the updated version of the Ethernet port (Contact Galooli Technical Support for an updated version file)and click “Program”. Make sure that the progress bar in the application gets to 100%.
...
7. In order to To make sure that the update is succeded please close the Power Center and open it again.
Connect to the Elara and check that you see the “EXTENDED” note near the Elara version number.
...
...
The ethernet version can be also verified in the ZonMax > unit settings > hardware > unit version
...